CRB Cleaning Systems, a CRB International Company

CRB UV Inspection Flashlight: Find Hidden Urine and Organic Stains Before the Clean

A handheld UV light that shows the crew where the problem is before the chemistry goes down. What is in CRB's UV inspection kit, who uses it, and how to inspect a room in a few minutes.

At a glance

~40 minwith CRB Dry Compound
UV flashlight inspection + spotter + low-moisture CRB pass
Standard BlueSoft Gray
TM3 (12") / TM4 (15") / TM5 (20")

The 3-step process

  1. 1

    Apply compound or encap pre-spray

    A light, even application. No flooding, no soaked backing.

  2. 2

    Counter-rotating cylindrical agitation

    Two brushes turn against each other, lifting the pile and working chemistry in.

  3. 3

    Lift soil & back in service

    Vacuum the captured soil and reopen the space, often the same shift.

CRB vs. traditional wet extraction & rotary

✓ CRB low-moistureWet extraction / rotary
Dry timeAbout 40 min or less with CRB dry compoundSoaked carpet can still be damp the next morning
Water in the floorAbout 85–90% less water (CRB's comparison)Floods the pile and backing
Wick-back & odorFar less moisture left to wick back or sourMoisture in the backing can wick, brown, or smell
Pile & surfaceCylindrical brushes lift and groom the pileRotary pads can distort pile; CRI 204 advises against rotary on carpet
Equipment40–62 lb, standard outlet, fits a closet or vanTruck access or portable extractor with hoses and tanks

Keep a periodic hot-water extraction for heavy, oily, or salt-loaded soil. Dry time depends on humidity, airflow, and application rate.

The CRB UV Inspection Flashlight is a handheld ultraviolet light. Under it, many urine, pet, and other organic stains glow that are hard to see in room lighting. Operators use it before the clean, on carpet, mattresses, and restroom floors, so the spotter and the counter-rotating brush (CRB) pass go exactly where they are needed. It is an inspection tool: it shows where to work, and the cleaning is done by the chemistry, the brush, and the vacuum.

Video // CRB officialCRB UV Light Inspection Kit: unboxing and demonstration

What is in the kit

CRB UV inspection flashlight laid out with its charger, wrist strap, and rechargeable lithium-ion battery

The kit as CRB ships it: the flashlight, a rechargeable 18650 lithium battery, the charger, and a wrist strap, with a carrying pocket and storage box.

The flashlight has an aluminum body and runs on a rechargeable lithium battery. CRB states about 30 hours of use on a full charge. The UV flashlight is sold in CRB's parts store.

Who uses it

  • Hotel housekeeping, on departure-day inspections of the carpet along the bed line and of the mattress and box spring. The routine is in Hotel guest-room turnover.
  • Pet-friendly properties and apartment turnovers, to find dried urine spots that room lighting hides. See Commercial pet stains, odor and embedded hair.
  • Restroom and janitorial crews, to find urine around fixtures, in grout lines, and along partition bases that the mop missed.
  • Cleaning and restoration contractors, to find the source of an odor before quoting the job, and to show the customer what was found.
  • Facility managers, to document a room's condition at move-out or check-out, with photos taken under the light.

How to inspect a room

  1. Darken the room. Close the curtains and switch off the lights. The darker the room, the more the light shows.
  2. Sweep low. Hold the light close to the floor and angle it across the pile. Work the bed line, along walls and doors, around furniture legs, under desks, and around restroom fixtures.
  3. Mark and record. Tape each spot or note it on the room card, and take a photo under the light.
  4. Treat, then recheck. After the spotter and the CRB pass, check the spots again at the next turnover. A spot that fades was on the surface. A spot that returns is deeper in the carpet, often in the pad.

What the flashlight does not do

  • It does not clean or sanitize. It shows where to work. Spots are removed by the spotter, the encapsulator or dry compound, the brush, and the vacuum.
  • A glow is not proof. Some detergent residues, fabric brighteners, and adhesives glow under UV too. Use the light to decide where to look closely, then treat what you find.
  • It does not see into the backing. The light shows the face of the carpet. Odor that keeps coming back after a spot fades is usually in the backing or the pad, and needs to be treated at the source.

Safety

Never shine the flashlight into anyone's eyes, including your own, and follow the safety notes that come with it. Charge the battery with the charger supplied in the kit.

Where it fits in a program

The flashlight comes first on routes where odor and stains are part of the complaint list: hotel guest rooms, pet-friendly rooms, apartment turnovers, and restrooms. Find the spots with the light, treat them with the right spotter, then make the interim CRB pass described in What is dry cleaning. Keep one light on each housekeeping or janitorial cart, and a charger in the supply room.

Related reading

Interactive configuration tools // apply this guide to your floor